DirectOut PRODIGY.MX - Changelog 14-10-2025

New versioning scheme: System YY.MM.BB (year.month.build version)

************************
System v25.08.2 (14-10-2025)
New Features
- HOME service now handles channel selection on RAV.IO gracefully (Firmware HW 0.39 / SW 1.25)

Bugfixes
- NMOS: Bulk requests for IS-05 ← fixed
- MILAN.IO: DHCP status was not correctly reported in globcon (and API) ← fixed


************************
System v25.08.1 (10-09-2025)

Bugfixes
- [DO-458] MADI2/4.SRC.IO settings were sometimes not applied to the module


************************
System v25.08 (22.08.2025)

New Features
- Dual Network Audio (DNA) module support
- RAV.IO WebUI via OOB (OOB license required)
- OSC support
- Loudness Metering
- DTMF Key generator as matrix source

Improvements to existing features
- Performance improvements for internal service communication
- HOME - “Effective Gain” support added, Bugfixes
- [ DO-121 / DO-121 ]  - mute output signals during boot

Bugfixes
- [ DO-414 ] Full Access Matrix enables Sum Bus as source
- [ DO-413 ] OSC on Prodigy MX "persist" not working with MatMix Faders
- [ DO-352 ] MADI2/4 modules - High pitch noise during boot (fixed in MADI2/4 firmwares)
- [ DO-325 ] AES/EBU enable sync not working (globcon)
- [ DO-313 ] Transparent Bit not OFF after "reset device"
- [ DO-129 ] Headphone DAC noise
- [ DO-111 ] Reset Device - missing parameters

Known issues
- HOME requires RAV.IO Firmware HW 0.29 / SW 1.02.3 should be used as the channel mapping feature is not yet support by HOME. The feature will be added with an update soon.
- HOME does not yet support DNA modules
- DANTE.IO with Brooklyn 3 in slot 1 and 4 of PRODIGY.MX has audio issues on the TX side. A fix is under test and available on request.


************************
Build 7 (04.03.2025)
Features
-initial HOME* support (BETA)
-System reboot via command from front panel and globcon

Bugfixes and Improvements:
-improved hardware watchdog for control resilience
-improved internal service management
-improved Fan Control in silent mode
-improved IP address assignment in DHCP mode
-device gets the same IP address also after update to new system images
-PSU status information could lock up ← fixed
-improved exception handling to avoid potential JSON API crash
-improved logging
-Bugfixes in SNMP Service

* HOME and NMOS OOB are licensed features

-NOTE: NMOS-OOB is NOT yet available in this release.

************************
Build 6 (5.8.2024)

- USB.IO support added
- HOME: support multiple NATS
- improved information in support archive

Changes
- improvements to internal watchdog
- improved TCP/IP connection handling to avoid potential unavailability of the device
- LLDP support

Bugfixes
- Ember+: added missing DSP controls for PRODIGY.MX
- HOME: service did not start automatically after reboot <- fixed


************************
Build 5 (14.05.2024)

Features
- added more version information to support archive

Bugfixes
cored/muxer: Issues with control communication between MADI2/4 modules and host on long running devices <- fixed


************************
Build 4 (04.04.2024)

Features
- 64 Input Managers
- 64 ch Automix
- 64 Summing Busses
- 64 Flex Channels
- 64 x 64 MatMix
- IIR Filters
- Dynamics
- Delays
- EARS for all input channels
- MADI4.IO and MADI4.SRC.IO support
- HOME (BETA)

Changes
- FPGA: improved MADI receiver

Bugfixes
- automator: issue matching OSC integer values <- fixed


************************
Build 3 (18.01.2024)

Features
- Video sync added

Bugfixes
- FastSRC on MADI Input 2 not working at 2FS / 4FS <- fixed
- SRC control for SRC modules not working on slots 2-6 <- fixed
- Headphone DAC configuration for 2FS / 4FS missing <- fixed


************************
Build 2 (19.12.2023)

Features
- Support for MADI2.BNC.SRC.IO, MADI4.IO and MADI4.SRC.IO

Bugfixes
- Net mask CID translation did not work properly
- replaced wrong automator binary
- front panel: improved behaviour of snapshot list


************************
Initial release (17.10.2023)