DirectOut ANDIAMO / ANDIAMO 2 Firmware ReadMe, 2018-05-22 Version 6.7 - MADI receiver: unlock detection improved Version 6.6 - new feature: Front panel brightness dimmable - improved mute behaviour during start-up Version 6.4 - new feature: summing bus with dithering - improved behavior of DA-Mutes Version 6.1: - phase reverse issue at analog output (only devices with new DA converters) <= fixed Version 5.3 - fix in gui Version 5.1 - fixed issue with AES at 4 FS (XT only) Version 4.9: Features: - Output Gain for analog outputs - 'Mute All' Function for output gains - AD/DA Calibration - adaption of AD/DA reference level in 0.1 dB steps. The calibration is applied when the ANDIAMO is set to input or output level 'LOW'. - 4 FS Support - sample rates up to 176,4 / 192 kHz - Disable MADI remote - New switch, forces remote functionality to USB only, even if there is incoming control data via MADI. The new features are accessible with ANDIAMO Remote v2.5 or higher. Version 4.1: Features: - 'Display Dark' added to mute LED display - 'Identify' added to determine selected device (in scenarios with several devices involved) - 'Extended Routing' added for devices with two MADI ports => individual access control of the two MADI I/Os Version 3.4: Bugfix: - Userbit transparency for AES I/Os was turned on by default preventing Serial-over-MADI from working <- fixed Version 3.3: Bugfix: - SRC settings were not restored correctly after reboot (ANDIAMO.XT SRC and ANDIAMO 2.XT SRC only) Version 3.2: Features: - supports DARS (AES11) as sync source for WCK input Version 3.1: Features (ANDIAMO 2 only): - Priority setting for redundancy mode -> switch-back to priority port if signal returns (setup requires Software v1.4.1) Version 3.0 Bugfixes: - Delay compensation did not work since last firmware release <- fixed Version 2.9 Features: - redundancy mode switchable (ANDIAMO 2 only) Version 2.8 - Maintenance update (one Firmware release number for the complete ANDIAMO Series) Version 2.5 - Improved stability of serial embedder Version 2.4 Features: - Remote Control support - Matrix Mode: NOTE: The Matrix Mode can be activated and de-activated without software on the front panel: Select the Bank menu, press and hold the SET button until both Bank LEDs are lit (Matrix Mode on) The same procedure de-activates the Matrix Mode and returns to standard Bank routing. The current Matrix routing is stored in the background and can be used without software connection at any time. - Fan Control via Software Version 1.8 Features: - MADI Input no lock -> Out Level blinks slowly - Delay Compensation: If ANDIAMO sees an ANDIAMO at its MADI input, delay compensation for the MADI output is applied. Active delay compensation is dipslayed by 'heart beat' on bank LED. Bugfixes: - Channel 56 not available on 56ch MADI input <- fixed DirectOut GmbH, 2014