DirectOut ANDIAMO.XT / ANDIAMO 2.XT (SRC) Firmware ReadMe, 2018-05-22

Version 6.7
- MADI receiver: unlock detection improved

Version 6.6
- new feature: front panel brightness dimmable
- improved mute behaviour during start-up

Version 6.4
- new feature: summing bus with dithering
- improved behavior of DA-Mutes


Version 6.1:
- phase reverse issue at analog output (only devices with new DA converters) <= fixed


Version 5.3
- AES receiver modified
- fix in gui


Version 5.1
- fixed issue with AES at 4 FS


Version 4.9:
Features:
- 'Mute All' Function for output gains
- 4 FS Support - sample rates up to 176,4 / 192 kHz
- Disable MADI remote - New switch, forces remote functionality to USB only, even if there is incoming control data via MADI.

The new features are accessible with ANDIAMO Remote v2.5 or higher.


Version 4.5:
- Output Gains for AES and analog Outputs
- AD/DA fine calibration in .1dB steps. The calibration is applied when the ANDIAMO is set to input or output level 'LOW'.


Version 4.1:
Features:
- 'Display Dark' added to mute LED display
- 'Identify' added to determine selected device (in scenarios with several devices involved)
- 'Extended Routing' added for devices with two MADI ports => individual access control of the two MADI I/Os


Version 3.4:
Bugfix:
- Userbit transparency for AES I/Os was turned on by default preventing Serial-over-MADI from working <- fixed


Version 3.3:
Bugfix:
- SRC settings were not restored correctly after reboot (ANDIAMO.XT SRC and ANDIAMO 2.XT SRC only)


Version 3.2:
Features:
- supports DARS (AES11) as sync source for WCK input


Version 3.1:
Features (ANDIAMO 2.XT only):
- Priority setting for redundancy mode -> switch-back to priority port if signal returns (setup requires Software v1.4.1)


Version 3.0
Bugfix:
- Delay Compensation did not work since last firmware release <- fixed


Version 2.9:
New Features:
- switchable Userbit transparency for AES inputs (requires software v1.3)
- Redundancy Mode switchable (ANDIAMO 2.XT only)


Version 2.8:
New Features:
- Remote Software Support
- Matrix Mode (per-channel routing)
	NOTE: The Matrix Mode can be activated and de-activated without software on the front panel:
	Select the routing menu, press and hold the SET button until all Routing LEDs are lit (Matrix Mode on)
	The same procedure de-activates the Matrix Mode and returns to standard 32ch routing.
	The current Matrix routing is stored in the background and can be used without software connection at any time.

- Fan Control via Software


Version 1.6:
New Features:
- Fallback mode for AES input to MADI routing:
  The routing Matrix for MADI output provides another setting (both AES and A/D LED lit).
  In this 'fallback mode' the AES input is routed to the MADI output. In case the AES input fails (no lock)
  the device switches to analog input for the respective channels only! All other inputs remain unchanged as
  long as they receive a valid AES input signal.


DirectOut GmbH, 2015