DirectOut PRODIGY.MP - Changelog 2020-11-24 ************************ Build 11 NOTE: This release requires globcon version 1.5.0 New Features Snapshots can be stored in the device and recalled stand-alone from the front panel "Configuration" and "Show" Mode Ember+ OSC Changes Improved MADI receiver Improved file handling for configuration data ************************ Build 10 NOTE: This release requires globcon version 1.4.0 New Features Channel Link GROUPS: Flex Channels, MatMix Masters, Sum Bus Masters and Hardware Outputs can be assigned to up to 16 groups basic MIDI-over-MADI control support (Gains, P48, PAD -> use PRODIGY MIDI PlugIn in globcon) improved Fan speed measurement improved JSON parsing and creation Bugfixes improved DA Mute during power-on Critical: AoIP modules could be set and held in reset state after several weeks without reboot <- fixed Dynamics: Stereo link issue fixed Dynamics: Gain Reduction issue fixed minor bugfixes and improvements for reset to default values and JSON commands FrontPanel: Output Levelmeters did not work <- fixed FrontPanel: Phones Mute Button was not updated correctly in all cases <- fixed ************************ Build 9 (Release) NOTE: This release requires globcon version 1.3.0 New Features Fast SRCs (bidirectional low latency asynchronous SRC) for MADI and NET I/Os 32 IIR Filters offering the combination of two filters selectable from All Pass, Low/Hi Pass, Low/Hi Shelf, Peak, Notch, Band Pass, Gain, RIIA Production/Playback Enhanced Dynamics with Mono/Stereo Link, Side Chain and Parallel Compression Added 32 Input Managers, with Signal Lock and selectable Level Coherence detection, selectable STEREO Link behavior, Sources auto level trim tool MIDI-Matrix (incl. support for MIDI-over-MADI tunneling) LTC to MTC converter Sine wave, Pink noise and white noise generators Enhanced Automatic Redundancy Switching (EARS) for NET and MADI I/Os Levelmeter speed configuration Bugfixes Lock state not preserved on page reload via Browser <- fixed Bit transparency for ST2110-31 and AES I/Os did not work properly <- fixed improved globcon bridge startup behaviour ************************ Build 8 (Release) NOTE: This release requires globcon version 1.2.1 New Features Compressor/Dynamics added transparent mode for MADI and NET I/Os for ST2110-31 support SFP port support for Management network interface added Fan control with setting for temperature threshold and silent mode Front panel: Locking function with PIN entry and auto lock Front panel: optional home view with big LTC display (tap on LTC to activate) IMPROVEMENT: Update now preserves network interface configuration IMPROVEMENT: Many internal improvements around Flex Channel handling Bugfixes BUGFIX: clock source changes were not always displayed correctly on front panel BUGFIX: MUTE ALL button was not displayed as active if the MUTE ALL state was left by tapping on one of the MUTE groups instead of the MUTE ALL button IMPROVEMENT/BUGFIX: PAD initialisation during boot (MIC8.x modules)